Daily Archives: June 17, 2025

Pultruded Cooling Tower Supplier in United Arab Emirates

1.High heat transfer performance with lower back pressure. Condensation occurs inside the tube, while evaporation occurs outside.Heat transfer performance depends on the wet bulb temperature, which is generally 8-14℃ lower than the dry bulb temperature.Single-stage heat exchange. 2. Water conservation. The circulation water is only 1/5 of the...

Pultruded Cooling Tower Manufacturer in United Arab Emirates

19 Main components   1. Coil: The coil is the main heat exchange surface of the evaporative condenser. It consists of a series of horizontal tubes with fins that increase the surface area exposed to the air and enhance heat transfer.   2. Fan system: The fan system creates a draft that drives air through […]

Coil cooling tower Supplier in United Arab Emirates

Evaporative condenser is a type of heat exchanger used to transfer heat from process fluids to the atmosphere. Unlike a direct air-cooled condenser, an evaporative condenser uses water as the cooling medium. The process fluid passes through a tube bundle while water is sprayed over the tubes. As the water evaporates, it removes heat from […]

Coil cooling tower Manufacturer in United Arab Emirates

Fully optimized structure design, double air inlets can effectively prevent the surface of the tube bundle from fouling Softened cooling water circulates in the closed circuit, thereby eliminating the efficiency reduction and system failures caused by floaters, dirt and other matters entering the cooling water system. High fan cylinder exhaust...

Closed Circuit Cooling Tower Supplier in United Arab Emirates

Hot process fluid enters the tube bundle from the inlet, and the spray system and fan system are started at the same time. Spray water is evenly sprayed on the surface of the tube bundle and a large amount of the air enters from the air inlet louver at the top of the tower and […]
1 2